How to Do Viking Chain Knitting

    CRAFTS CLASSES
    TO INSPIRE CREATIVITY
    by eHow Contributor

    About the Author

    This article was created by a professional writer and edited by experienced copy editors, both qualified members of the Demand Media Studios community. All articles go through an editorial process that includes subject matter guidelines, plagiarism review, fact-checking, and other steps in an effort to provide reliable information.

    ×

    Also known as trichinopoly, this technique creates chain work that can be either lacy or dense, depending on the number of loops woven into in each round. The method is simple to learn, but takes a little practice to master. And yes, the Vikings really did this!

    Things You'll Need

    • Fine gauge wire
    • Wire cutters
    • Wooden dowel, Allen wrench or mandrel
    • Needle nose pliers
    • Spare piece of wood
    • Power drill with various bits
    • Jewelry findings (optional)

    show more

    Make three or more loops, each a few inches deep, with about a foot of your wire. Wrap the bundle a few times near the base and then again closer to the working end, about an inch below the tip of the loops. This won't actually be part of the finished chain, so don't worry too much about looks.

    Fit the loops around the end of your dowel or mandrel. Using an Allen wrench gives you the benefits of the angles to work around, but you can cut a small notch at the top of a dowel to help pass the working wire around the loops you'll be making.

    Anchor a new piece of wire--your working wire--to the base, and then make your first loop. The working wire will follow down the side of one of the starter loops, curve under where two loops rest side-by-side, behind the sides of the two starter loops and then out and down again to the right, making a counter-clockwise e-loop. Pull it snugly, but leave enough space to work around.

    Continue to "knit" these e-loops, working to the right, joining each of the starter loops together until you come back to the beginning.

    On the next row, using the same method, bring your next loop behind the crossed wires that formed the bottom of the first loop you made. This is how you will continue to build your chain, loop by loop, shifting the growing length of chain up the dowel, wrench or mandrel as necessary.

    To make a more dense chain you can bring your loop behind the second cross up (for double weave) or even the third (for triple weave) for a very sturdy chain. Keep in mind that the denser the chain, the less flexible it will be.

    At the end of your working wire, clip it just after the last loop completed, tucking the cut edge inside the chain. Make a small hook in a new piece of wire and draw the straight end behind that last loop, securing the hook around that loop. Continue weaving as before.

    Weave the length you think you will need but know that you'll gain a few inches once the chain is drawn out.

    Make a draw plate by drilling several holes in decreasing sizes about an inch apart in your piece of hardwood.

    Starting with the largest hole, pull your chain through the hole once or twice, then work your way down through each smaller hole until your chain has increased in length, evened out in texture and becomes more flexible.

    To prepare the chain for use, clip and remove the starter loops and extend the end of the wire out to make loops, hooks or feed through a decorative end cap to hide the not-so-pretty ends.

    • To save your fingers, pull the wire through with the needle nose pliers, just be careful not to kink up the wire.
    • Another use for the needle nose pliers is to tidy up your loops from time to time. Gently squeeze along the rows to straighten them and keep the spaces open to slip the working wire through.
    • To avoid injury, wear protective gear (gloves and eye protection, especially) while working with the power drill.